SCHEDULE AN APPOINTMENT FOR A GENERAL MAINTENANCE INSPECTION
Airtek Mechanical Heating & Air conditioning
contractor in New Jersey, provides fast 24 hour
Hvac repair services, like AC service, furnace repair,
boiler repair, AC repair, refrigeration repair, system
replacements and maintenance tune-ups.
For all residential & commercial Hvac
equipment. We have over 8 years experience in the
field alone and 10 years in preventive maintenance.
Our maintenance services include items listed below.
contractor in New Jersey, provides fast 24 hour
Hvac repair services, like AC service, furnace repair,
boiler repair, AC repair, refrigeration repair, system
replacements and maintenance tune-ups.
For all residential & commercial Hvac
equipment. We have over 8 years experience in the
field alone and 10 years in preventive maintenance.
Our maintenance services include items listed below.
10-Point Check-Up For Central Air conditioning and Heating Systems
- Check Overall Heating, Cooling or Heat-Pump System Operation
- Test and Inspect Run Capacitor & Start Capacitor
- Check Condenser Coil & Evaporator Coil Temp Drop
- Check Fan Speeds For Summer A/C Operation
- Clean Condensation Drain & Inspect Drain Pan
- Clean out Leaves and Debris inside condenser
- Check Air Filter & Replace Blower Drive Belts
- Lubricate Motors Bearings, Pulley, Shaft & Wheel
- Check Condensate Pump & Drain Trap Lines
- Check Refrigerant Levels R-22 or R-410A
- Take Superheat & Sub-cooling and Adjust Charge
- Check for Loose Parts or Vibration Noise
- Check 24volt Lines for Cut or Exposed Wire
- Check All Motor Amperage Draw & Compressor RLA
10-Point Heating Central Hot Forced Air & Baseboard Gas Heating
- Start Up Heat & Check Sequence of Operations
- Check Pressure Switches & Test With Draft Simulator
- Check the Heat-Exchanger for Cracks or monoxide smells
- Check Furnace for Loose or Worn Parts
- Check Furnace for Abnormal Vibrations and Proper Draft Venting
- Check Electrical Circuit to Furnace including Thermostat
- Adjust Manifold Pressure on the Gas Furnace
- Check Gas Valve operation & Inspect Thermo-coupling
- Check Ignition System and Clean Pilot burners
- Check Furnace Air Filter clean or replace
- Check Rotation and Lubricate Blower Motor
- Check Electrical Safety Circuits for Proper Operation
- Adjust for Peak Operation System Efficiency